Cubicle Curtain Fabrics Nearly all the manufacturers use fabrics that possess a long-life flame retardant capacity. The curtain cloth would be suspended from a curtain track, curtain carriers, or other types of supporting structures. However, curtain tracking is the most common support for most of the cubicle curtains. In the case of hospital curtains, the cubicle curtain fabric would consist of different types of woven fabrics that would be stitched together. The top portion of the cubicle curtain would be prepared from a mesh fabric to allow light and air flow into the cubicle. The lower portion would be of opaque cloth to furnish complete privacy.
Once the curtain has been hung it is ready to be embellished. Start with the left or right curtain first and open it up so that it is spread out wide across the window, this way so you can see exactly where you have made the marks and where you are going to place the roses. For this purpose I am going to attach six roses to each curtain using a sequence of three. Remove the plastic backing from the rose by giving it a good pull; your rose will now be in two parts, (the backing and also the rose and stem). Start at the top left hand corner of the curtain, using the awl push a hole through the organza where you have made your first mark, NB its easier and is likely to make a cleaner hole if you hold the fabric on either side of the mark that you made whilst pushing the awl through. Once the hole has been made (ensure that it is big enough for the stem to go through) push the stem of the rose through the hole and secure the rose by pushing the plastic backing back onto the stem which will now be facing the back of the curtain, push it up as far as it will go, this will ensure that the rose wont fall off when its being laundered.
NB It is important that you get the sequence 100% correct before you make the marks and the holes, should you realise that you want to change the roses around after the holes have been made you run the risk of having gaping holes in your curtain which could look rather messy. The next step will be to measure the top width of the window frame and then cut the dowel or curtain wire in order to fit (using either a pliers if it is wire or a hand saw if you are cutting the dowel). If you are using curtain wire go to the top of the window frame and attach one screw eye on the left and right hand side of the frame. Ready made organza curtains should have tabs at the top, attach hooks to both ends of the curtain wire and then thread the wire through the tabs of both curtains and attach the wire to the screw eyes on the window frame. If you are using a wooden dowel use cup hooks and not screw eyes for the dowel to rest on. Thread the dowel through the tabs and place on cup hooks.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does BengalsJerseys claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.