The curtain fabrics are supplied by nearly all the manufacturers in different colors and patterns so that they match the interior of the rooms where the cubicle curtains are used. The specifications of the fabrics and their compliance to fire retardant standards of the state government should be studied and confirmed before placing orders for cubicle curtains. Curtain Track and Curtain Carriers The cubicle curtain tracking is done with a curtain track that had been specially designed and bent to meet the specifications and requirements at the place of installation. The curtain tracking systems are normally powder coated and the most common powder coating color is white, so that the curtain carriers blend with the ceiling. Moreover, the curtain track is generally provided a fair amount of lubrication by the application of a Teflon coating, so that the cubicle curtain fabric could be easily operated, if opening or closing of the enclosure is required. The curtain tracking system is also provided with gliding carriers so that the above work is made much easier.
Repeat the process on the top right hand side of the same curtain, now find the centre between the two roses and to create a bit of interest attach the middle rose slightly lower than the rose on the left and the right. Place the fourth rose underneath the third middle rose but slightly lower. Place the fifth rose to the left side of the fourth one but slightly lower (should be in line with the first rose attached at the top left side of the curtain), now the attach the sixth rose to the right of the fourth rose but slightly lower (should be in line with the second rose attached at the top right side of the curtain. Your sequence of six is now complete and I personally find that this pattern is most pleasing to the eye, you could of course embellish the whole curtain, it really depends on the look which you are trying to achieve.
Quality curtain tracking is made of 16 gauge extruded aluminum and is typically sold in eight foot lengths. If shorter lengths are required, tracking may be easily cut down with a hacksaw. Curves pre-bent to 45 deg. and 90 deg. are available for applications requiring the curtain to bend around a room; curves are 2 feet by 2 feet and bent at a 12 inch radius. Curtain tracking can be attached to solid or false/drop down ceilings using screws or clips. Attaching the tracking to a solid ceiling requires the use of screws; screw directly into ceiling studs whenever possible. Holes will need to be drilled into the tracking at each attaching point. It is not always possible to screw into a stud. When this occurs, the use of an anchor is necessary. An anchor is pressed into a pre-drilled hole. As a screw is inserted into the anchor; the anchor expands and grabs firmly to the ceiling. Drop down/false ceilings require clips which are attached to the ceiling grid. There is a hole tapped into each clip that accepts a screw from the curtain tracking. These clips should be placed every 30".
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does BengalsJerseys claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.